INVESTIGATOR 563

Peter, that’s thinking outside the square for sure. Lots of old LPs kicking around too.

Don’t use blues records though you might get the centreboard blues. That was terrible I’m going to bed

Well Ozzie, don't get the blues then or you might not sleep

Hi all, just been re reading some old posts and came across this one. As a matter of interest, when I fitted my centreboard, I also fitted a couple of thin pieces of lubricated nylon as square washers to the front lower sides of the centreboard case so that when the centreboard is lowered, it slides between the two fitted pieces which takes up most of the difference in size between the thickness of the centreboard and the opening of the centreboard case. These pieces are only two or three inches long and don't interfere with future removal of the centreboard at all but what they do is support the centreboard at the bottom of the case from trying to flog sideways when the centreboard is down. This should take a lot of pressure off the thrust of the large washers each side of the centreboard which would otherwise put toggle pressure on the pivot bolt. Also, I shaped the leading edge of these supports so that the centreboard would not catch on them as it entered on the last part of the downward swing of the centreboard. They are held in place with Sikaflex and was very easy to do.
Cheers